Cisco 352-001 Practice Test Questions

DumpsSchool Cisco 352-001 dumps contain updated knowledge which helps network Designers, networking professionals to pass the CCDE DESIGN Certification written 352-001 exam.

Try it Latest DumpsSchool 352-001 Exam dumps. Buy Full File here: https://www.dumpsschool.com/352-001-exam-dumps.html (249 As Dumps)

Download the DumpsSchool 352-001 braindumps from Google Drive: https://drive.google.com/file/d/1cExqS79nPc1Rg_WFSllVOvu29uL7fEXb/view (FREE VERSION!!!)

Question No. 1

What is design considerations of policy-based routing?

Answer: B

Question No. 2

Which are two data plane hardening techniques? (Choose two)

Answer: A, B

Question No. 3

An network is designed to use OSPF to reach eBGP peers. Which condition should be avoided in the design to potentially prevent the eBGP peers do not flap continuously in case of link failure?

Answer: C

Question No. 4

Refer to the exhibit.

Each branch network must connect to the HQ and other branch networks over the phase 2 DMVPN network using a single tunnel interface. OSPF is running over the DMVPN network. Which network type is compatible with the DMVPN tunnel and ensures that the next hop of any route is unchanged?

Answer: C

Question No. 5

How can jitter be compensated on an IP network that carries real-time VoIP traffic with acceptable voice transmission quality?

Answer: D

Question No. 6

Which open source message broker is in the Cisco Cloud Center?

Answer: C

Question No. 7

Refer to the exhibit.

An enterprise has three sites over a Layer 2 Metro Ethernet ELAN service. 100Mb/s and 10 Mb/s links have been provisioned to provide redundancy for the head office. When OSPF routing enabled to provide connectivity and the correct bandwidth statement has been applied to each interface, the branch sites observe two equal-cost routes to the head office. The enterprise wants to send all traffic through the 100 Mb/s link and use the 10Mb/S link strictly as a backup. Which OSPF network type must be set to ensure that the head office 100 Mb/s circuit is preferred over the 10 Mb/s circuit, at the same time minimize the amount of configuration required on all of the routers throughout the network?

Answer: C

Question No. 8

Which load balancing option for IP-only traffic is the least efficient in terms of EtherChannel physical links utilization?

Answer: B

Question No. 9

When designing a network .Which method can be used to control the exit point for traffic an autonomous system, at the layer 3 control plane?

Answer: D

Question No. 10

In a VPLS design solution, which situation indicates that BGP must be used instead of LDP in the control plane?

Answer: A

352-001 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1cExqS79nPc1Rg_WFSllVOvu29uL7fEXb/view

Related Certification: Cisco dumps

Facebook Comments